Chapter 13 Troubleshooting
WAP3205 v2 User’s Guide
108
Advanced Suggestion
• If your computer is connected wirelessly, use a computer that is connected to a
LAN
port.
I can see the
Login
screen, but I cannot log in to the WAP3205 v2.
1
Make sure you have entered the password correctly. The default password is
1234
. This field is
case-sensitive, so make sure [Caps Lock] is not on.
2
This can happen when you fail to log out properly from your last session. Try logging in again after
5 minutes.
3
Disconnect and re-connect the power adaptor or cord to the WAP3205 v2.
4
If this does not work, you have to reset the device to its factory defaults. See
13.3 Internet Access
I cannot access the Internet.
1
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide.
2
Make sure the WAP3205 v2 is connected to a broadband modem or router with Internet access.
3
If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless
client are the same as the settings in the AP.
• Go to
Network > Wireless LAN > WDS
and check if the WAP3205 v2 is set to bridge mode.
Select
Disable
and try to connect to the Internet again.
4
Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
5
Check the switch on the WAP3205 v2’s side panel for your system operating mode setting.
• Use
AP
mode if your WAP3205 v2 bridges traffic between clients on the same network.
• Use
CL
(Client) mode if your WAP3205 v2 needs a wireless client to connect to an existing
access point.
• Use
UR
(Universal Repeater) mode if you want to have wireless clients associate with the
WAP3205 v2 and also want to connect the WAP3205 v2 to an existing access point.
6
If the problem continues, contact your ISP.
