ZyXEL Communications U-336E, User Manual

Page: 32 / 137

20 Basic Modem Operation
modem uses. By default, your modem uses result codes equivalent
to the ATX5 command.
The result code options will be covered more thoroughly in later
chapters.
Viewing S Register Values
Status registers (or "S-registers") contain values that determine the
modem’s operating characteristics. Whenever you send an AT
command to your modem, you are actually changing the value of an
S-register.
You can use the Sr? command to view the value of S-register ‘r’.
For example, to view the value of S-register S0, which controls
auto-answering, type ATS0? and press Enter. The modem responds
with a three-digit character showing the value of this register,
followed by OK. A value of 002, for example, means your modem
will auto-answer incoming calls after the second ring.
Some S-registers are bit mapped. For these registers, you can use
the Sr.b? command to read their values.
For example, to read the value of S-register S35, bit 7, type
ATS35.7? and press Enter. The modem responds with an
appropriate value, followed by OK.
Changing S Register Values
You can use the ATS0=n command to change the value of an S-
register.
For example, to have your modem auto-answer an incoming call
after two rings, set S-register 0 to 2. Be sure the n value is between
1 and 255. If n is set to 0, your modem will not answer incoming
calls.