U-1496E does not have the leased line jack.
((MODE-37))
Refer to U-1496 rear panel description and modem connection for
U-1496E's rear panel explanation.
U-1496P FRONT PANEL
Fig. 3-7 shows the U-1496P front panel. The following explains
the connectors and indicator on the front panel.
((Figure 3-7: U-1496P FRONT PANEL - redraw))
POWER Power jack connector for power connection.
The U-1496P uses a DC 12V power source.
You can use either the attached AC power adaptor
or car battery through the cigarette lighter cable as the power
source.
LED A dual color LED for status indication,
Green On: indicates power on idle state.
Green flash at
0.5 Hz: indicates dial state
1.0 Hz: indicates handshake state
20 Hz: indicates data state
2 sec ON/4 sec OFF: indicates ringing.
Red ON when in data state: indicates bad signal quality.
Red and Green both FLASH: the number of flashes indicate
the error code of power-on selftest.
LINE RJ-11 phone jack for 2-wire dial-up line
connector, connect to wall outlet jack or a cellular phone
adaptor.
PHONE RJ11 phone jack for connection to a
telephone set.
U-1496P REAR PANEL
Fig 3-8 shows the U-1496P rear panel. The following explains the
connector on the rear panel.
((Fig 3-8: U-1496P REAR PANEL - redraw))
EIA-232D Serial port DB25S female connector, for connection to
the serial port of a DTE (computer/terminal). Pin assignments are
listed in Appendix A for your reference. This serial port
connector supports both synchronous and asynchronous
communication.
MODEM CONNECTION
((Fig 3-9: U-1496P CONNECTION for cellular communication -
redraw))
Fig 3-9 shows the modem connection with U-1496P. There are three
ways of connecting power to your U-1496P. Select the most
