ZyXEL Communications SMG-700, User Manual

Page: 31 / 80

STB-1001S2 User’s Guide
31
C
H A P T E R
3
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• STB Access and Login
• Internet Access
3.1 Power, Hardware Connections, and LEDs
V
The STB does not turn on. None of the LEDs turn on.
1
Make sure the STB is turned on.
2 Make sure you are using the power adaptor or cord included with the STB.
3
Make sure the power adaptor or cord is connected to the STB and plugged in to an
appropriate power source. Make sure the power source is turned on.
4
Turn the STB off and on.
5 If the problem persists, contact the vendor.
V
The POWER ( ) LED is red, or blinking green.
1 The STB may be in standby mode. Try using the remote control’s button to turn it on.
2
Wait for a short while. The STB may take a minute or so to start up.
3 If the LED still does not turn steady green, turn the STB off and on.
4
If the problem persists, contact the vendor.
V
One of the LEDs does not behave as expected.
1
Make sure you understand the normal behavior of the LED. See Section 1.2 on page 18 .