ZyXEL Communications Prestige 642M series, User Manual

Page: 21 / 86

Prestige 642M Series ADSL Bridge
Hardware Installation & Initial Setup 2-1
Chapter 2
Hardware Installation & Initial Setup
This chapter describes the physical features of the Prestige
and how to make the cable connections
.
2.1 Front Panel LEDs of the P642M
The LED indicators on the front panel indicate the operational status of the Prestige. The table below the
figure describes the LED functions:
Figure 2-1 Front Panel of the P642M
Table 2-1 Front Panel LED Description
PWR
The PWR (power) LED is on when power is applied to the Prestige.
SYS A steady on SYS (system) LED indicates the Prestige is on and functioning
properly while an off SYS LED indicates that the system is not ready or has
malfunctioned. The system is rebooting when the SYS LED is blinking.
LAN 10M
A steady light indicates a 10Mb Ethernet connection. The LED will blink when
data is sent/received.
LAN 100M A steady light indicates a 100Mb Ethernet connection. The LED will blink when
data is sent/received.
ADSL The ADSL LED is on when the Prestige is connected successfully to a DSLAM.
The LED blinks when data is sent/received. The LED is off when the link is down.
2.2 Rear Panel and Connections of the P642M
The following figure shows the rear panel connectors of your Prestige.
Figure 2-2 Rear Panel and Connections of the P642M