P100IH ISDN Router
7-4
Dial-In Server Configuration
Figure 7-3 Menu 13 – Default Dial-in Setup
From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes how to
configure the protocol-independent fields in this menu. For the protocol-dependent fields, refer to the
appropriate chapters.
The table below describes and contains information on how to configure each parameter in Menu 13 –
Default Dial-in Setup.
Table 7-2 Default Dial-in Setup Fields
Field
Description
Options
Telco Options: CLID
Authen
This field sets the CLID authentication parameter for all
incoming calls. There are three options for this field:
z
None
- No CLID is required.
z
Required
– CLID must be available, or the Prestige
will not answer the call.
z
Preferred
- If the CLID is available then CLID will
be used; otherwise, authentication is performed in
PPP negotiation.
None
Required
Preferred
PPP Options:
Menu 13 - Default Dial-in Setup
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
O/G Login= p100ih
O/G Password= ********
Multiple Link Options:
Max Trans Rate= 128
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= N/A
IP Count(1,2)= N/A
Session Options:
Edit Filter Sets= No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
