ZyXEL Communications PLA-450 - V3.60, User Manual

Page: 30 / 190

Chapter 3 The ENCRYPT Button
PLA450 User’s Guide
30
Figure 4 ENCRYPT Connection Procedure
5 Repeat step 4 in this section for the other powerline device you wish to connect. This
must be done within 120 seconds of pressing the ENCRYPT button on the PLA450.
6 Check the lights on the two powerline devices. Wait for about one minute while your
powerline devices connect. The HomePlug (
) lights on both devices turn on when the
connection is made.
V
If the HomePlug ( ) lights on both powerline devices do not light up, the
powerline devices are not connected. Repeat steps 3, 4 and 5 in this
section. If that doesn’t work, see the Troubleshooting in Section 14.7 on page
120 for suggestions.
7 To add more powerline devices to your network, press the ENCRYPT button on device
C (shown below) for more than 10 seconds until the HomePlug ( ) light flashes.
8 Then repeat steps 4 and 5 in this section using any powerline device ( A or B ) you have
connected using ENCRYPT and the powerline device you want to connect ( C ). You
must use the ENCRYPT button on both devices.
press 2 seconds
press 2 seconds
within 2
minutes