ZyXEL Communications P-661H Series, User Manual, Page: 124 / 383

P-661H/HW Series User’s Guide
124 Chapter 6 Wireless LAN
Figure 66 Start OTIST?
2 If an OTIST-enabled wireless client loses its wireless connection for more than ten
seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually
have the wireless client search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
3
When the wireless client finds an OTIST-enabled AP, you must still click Start in the AP
OTIST web configurator screen or hold in the RESET button (for one to five seconds)
for the AP to transfer settings.
4 If you change the SSID or the keys on the AP after using OTIST, you need to run OTIST
again or enter them manually in the wireless client(s).
5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run
OTIST. Therefore, if a new wireless client joins your wireless network, you need to run
OTIST on the AP and ALL wireless clients again.
6.6 MAC Filter
The MAC filter screen allows you to configure the
ZyXEL Device
to give exclusive access to up
to 32 devices ( Allow ) or exclude up to 32 devices from accessing the
ZyXEL Device
( Deny ).
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address
is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure this
screen.
To change your
ZyXEL Device
’s MAC filter settings, click Network > Wireless LAN > MAC
Filter . The screen appears as shown.