ZyXEL Communications NWA-3100, User Manual

Page: 64 / 294

Chapter 4 System Screens
ZyXEL NWA-3100 User’s Guide
64
4.3 Configuring Password
It is strongly recommended that you change your ZyXEL Device’s password. Click SYSTEM
> Password . The screen appears as shown.
If you forget your ZyXEL Device’s password (or IP address), you will need to reset the device.
See the section on resetting the
ZyXEL Device for details
Figure 33 Password .
The following table describes the labels in this screen.
First DNS Server
Second DNS Server
Third DNS Server Select From DHCP if your DHCP server dynamically assigns DNS server
information (and the
ZyXEL Device
's Ethernet IP address). The field to the
right displays the (read-only) DNS server IP address that the DHCP assigns.
Select
User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined ,
but leave the IP address set to 0.0.0.0, User-Defined changes to None after
you click Apply . If you set a second choice to User-Defined , and enter the
same IP address, the second User-Defined changes to None after you click
Apply .
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a machine in order
to access it.
The default setting is
None .
Apply Click Apply to save your changes.
Reset Click Reset to reload the previous configuration for this screen.
Table 5 System General Setup
LABEL DESCRIPTION
Table 6 Password
LABEL DESCRIPTIONS
Old Password Type in your existing system password (1234 is the default password).
New Password Type your new system password (up to 31 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Retype your new system password for confirmation.
Apply Click Apply to save your changes.
Reset Click Reset to reload the previous configuration for this screen.