Chapter 9 WAN
NBG6604 User’s Guide
57
IDLE Timeout
(second)
This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
PPPoE Service
Name
Enter the PPPoE service name specified in the ISP account.
WAN IP Address Assignment
Get automatically
from ISP
Select this option if your ISP did not assign you a fixed IP address. This is the default selection.
Use Fixed IP Address Select this option and enter your WAN IP address if the ISP assigned a fixed IP address.
DNS Server
First DNS Server
Second DNS Server
Third DNS Server
Select
O b ta ine d Fro m ISP
if your ISP dynamically assigns DNS server information (and the
NBG6604's WAN IP address). The field to the right displays the (read-only) DNS server IP
address that the ISP assigns.
Select
Use r- De fine d
if you have the IP address of a DNS server. Enter the DNS server's IP
address in the field to the right.
Select
No ne
if you do not want to configure DNS servers. If you do not configure a DNS server,
you must know the IP address of a computer in order to access it.
WAN MAC Address
The MAC address section allows users to configure the WAN port's MAC address by using the NBG6604’s MAC
address, copying the MAC address from a computer on your LAN or manually entering a MAC address.
Factory default
Select
Fa c to ry d e fa ult
to use the factory assigned default MAC Address.
Clone the
computer’s MAC
address - IP Address
Select
C lo ne the c o m pute r's MA C a d d re ss - IP A d d re ss
and enter the IP address of the
computer on the LAN whose MAC you are cloning.
Set WAN MAC
Address
Select this option and enter the MAC address you want to use.
Automatically
configured by
DHCPC
Select this to have the NBG6604 detect the relay server’s IP address automatically through
DHCP.
Manually
Configured
Select this if you have the IPv4 address of the relay server.
Border Relay IPv4
Address
Specify the relay server’s IPv4 address.
IPv4 mask length
Enter the subnet mask number (1~32) for the IPv4 network.
Remote IPv4
Address
Enter the IPv4 address of the remote gateway to which this interface tunnels traffic.
Multicast Setup
Multicast Setup
Select
IG MPv1/ v2
to enable multicasting. This applies to traffic routed from the WAN to the
LAN.
Select
No ne
to disable this feature. This may cause incoming traffic to be dropped or sent to
all connected network devices.
Auto-Subnet Configuration
Table 15 Network > WAN > Internet Connection: PPPoE Encapsulation (continued)
LABEL
DESC RIPTIO N
