ZyXEL Communications MS-7206, User Manual

Page: 55 / 94

Chapter 7 Installing Cards
MS-7206 Hardware Installation Guide
55
Figure 14 Installing a Module
Figure 15 Closing the Ejector Levers
Figure 16 Tightening Module Thumbscrews
7.4 Physically Removing Management and Interface Modules
Use the following procedure to remove management modules and interface modules from the
chassis.
1 Disconnect all cables from the module.
2 Loosen the two thumbscrews.
3 Pull the two ejector levers firmly until the front of the module is clear of the chassis. Pull
the ejector levers until they are perpendicular to the front panel.
4 Grasp the center of the front panel of the module with one hand and place the other hand
under the module to support it.
5
Slide the module out of the slot.
Figure 17 Loosening Module Thumbscrews