Chapter 6 Wireless
LTE7461-M602 User’s Guide
44
The following table describes the general wireless LAN labels in this screen.
6.2.1 No Security
Select
No Security
to allow wireless stations to communicate with the access points without any data
encryption or authentication.
Table 13 Network Setting > Wireless > General
LABEL
DESCRIPTION
WiFi Network Setup
Band
This shows the WiFi band which this radio profile is using.
2.4GHz
is the frequency used by IEEE
802.11b/g/n WiFi clients while
5GHz
is used by IEEE 802.11a/ac WiFi clients.
WiFi
Click
Enable
to enable
the wireless LAN in this field.
Channel
Use
Auto
to have the Zyxel Device automatically determine a channel to use.
Bandwidth
Select whether the Zyxel Device uses a
WiFi
channel width of
20MHz
,
40MHz
or
20/40MHz
.
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel
uses two standard channels and offers speeds of up to 300Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. The WiFi clients must also support 40MHz. It is often better to use the 20MHz setting in
a location where the environment hinders the
WiFi
signal.
Select
20MHz
if you want to lessen radio interference with other
WiFi
devices in your
neighborhood or the
WiFi
clients do not support channel bonding.
Control
Sideband
This is available for some regions when you select a specific channel and set the Bandwidth field
to
40MHz
. Set whether the control channel (set in the
Channel
field) should be in the
Lower
or
Upper
range of channel bands.
WiFi Network Settings
WiFi Network
Name
The SSID (Service Set IDentity) identifies the service set with which a
WiFi
device is associated.
WiFi
devices associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Max Clients
Specify the maximum number of clients that can connect to this network at the same time.
Hide SSID
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
This check box is grayed out if the WPS function is enabled in the
Network
>
Wireless
>
WPS
screen.
Multicast
Forwarding
Select this check box to allow the Zyxel Device to convert wireless multicast traffic into wireless
unicast traffic.
BSSID
This shows the MAC address of the wireless interface on the Zyxel Device when wireless LAN is
enabled.
Security Level
Security Mode
Select
More Secure (WPA2-PSK)
to add security on this
WiFi
network. The
WiFi
clients which want
to associate to this network must have the same
WiFi
security settings as the Zyxel Device. When
you select to use a security, additional options appears in this screen.
Or you can select
No Security
to allow any client to associate with this network without any data
encryption or authentication.
See the following sections for more details about this field.
Cancel
Click
Cancel
to restore your previously saved settings.
Apply
Click
Apply
to save your changes.
Summary of Contents for LTE7461-M602
Page 12: ...12 PART I User s Guide...
Page 26: ...25 PART II Technical Reference...
