ZyXEL Communications COMET 336, User Manual

Page: 18 / 70

Installation 11
If the User name and Password are incorrect or missing, type them in. Click on the
Connect button and your Comet 336 will dial the number and establish a connection to
your Internet Service Provider.
11RRWWHH 7KH GHIDXOW SURWRFRO IRU 'LDOXS 1HWZRUNLQJ LV 3RLQWWR3RLQW 3URWRFRO
333 ,I \RXU ,63 UHTXLUHV \RX WR XVH 6HULDO /LQH ,QWHUIDFH 3URWRFRO
6/,3\RXPD\QHHGWRFUHDWHDVSHFLDOORJRQVFULSWILOH%HFDXVHWKH
SURFHGXUHVIRUORJJLQJRQZLWK6/,3DFFRXQWVYDU\JUHDWO\IURP,63 WR
,63\RXVKRXOGFRQVXOWWKHWHFKQLFDOVXSSRUWGHSDUWPHQWRI\RXUVHUYLFH
SURYLGHUIRUWKLVLQIRUPDWLRQ
Setup for DOS Fax/Modem Software
After installing the Comet 336, use the following procedures to verify your modem
connections.
1. Install and load your communications software. If you need assistance, refer to the
manual that came with the software.
2. If your communications software requires you to select a modem, and the ZyXEL
Comet 336 is not one of the choices, you can either check our web site for the
driver or select the ZyXEL U-1496 modem. In many cases, the commands for these
modems are identical.
3. Select the following communication settings:
Setting Value
Baud rate 115,200bps
Data bits 8
Parity None
Stop bits 1
Flow control Hardware
Initialization string AT&F
Port COMn*
11RRWWHH :KHQVSHFLI\LQJDSRUWDVVLJQPHQWWKH
‘
Q
’
LQGLFDWHVWKHFRPSXWHUVHULDO
SRUWWRZKLFK\RXUPRGHPLVDWWDFKHG)RUH[DPSOHLI\RXUPRGHPLV
FRQQHFWHGWRVHULDOSRUW\RXZRXOGVHOHFW&20
4. Place your communications software in terminal or direct connect mode (your
communications software manual will explain how).
5. Look at the modem’s front panel and verify the TR LED is ON. If this LED is OFF,
your communications software is not addressing your modem at the correct COM
port. Make sure your software is set up for the same COM port to which your
modem is connected.