Page 10
On/Off
&
Dimming
To turn on the F8-200 press and release the Dimmer knob. Press and release
again to turn the light off. Turn the Dimmer knob to the right to increase
brightness and to the left to decrease brightness.
LED Display:
The LED display will shut off after 5 seconds of inactivity. To
make the display reappear, press either button.
Focus Adjustment
The focus knob contains a passive braking system that allows the bellows to
stay in place when the light is in a downward position. For this system to
work properly, there will be a small amount of rotational movement that
engages and disengages the brake at the focus knob without moving the
bellows. This is normal operation. The center screw that holds the focus
knob in place should not be overtightened or the braking system will not
work properly.
Turn the focus knob on the back of the unit to change the output between
spot and flood. At flood position the lens housing will automatically extend
approximately 1” [25mm]. Compress the lens housing below this level by
hand for packing & transport only. CAUTION: Do not move the lens housing
by hand between the flood & spot positions. Do not force the focus knob
past its end stops.
Focus Knob
Yoke/Handle
Mount
Dimmer
DMX Breakout Jack
Yoke/Handle
Mount
Power Input
MODE Knob to set
DMX Address & ZyLink
Summary of Contents for F8-200
Page 1: ...Zylight F8 LED Fresnel User Instructions v1 4 F8 D F8 T F8 B F8 200 The...
Page 7: ...Fig 2 Fig 1 Fig 4 Fig 3 Fig 6 Fig 5 Fig 7 Fig 8 Page 6...
Page 17: ...F8 200 Fresnel Parts Diagram Page 16 3 4 1 2 9 7 12 7 20 11 6 18 8 15 10 17 16 21 5 14 19 13...
