AC Dimmer
(Lutron & Clipsal
C-Bus System)
L
N
AC
L
N
LED
L N
N
Output
L
N
Input
Black
Zurik EMLV Dimmable
Power Supply
Output
L
N Blue
Input
Zurik EMLV Dimmable
Power Supply
Output
L
N
Input
Zurik EMLV Dimmable
Power Supply
LUTRON
AC Dimmer
L
N
AC
L
N
LED
DL/SL1
Output
L
N
Input
Zurik EMLV Dimmable
Power Supply
Output
L
N
Input
Zurik EMLV Dimmable
Power Supply
Output
L
N
Input
Zurik EMLV Dimmable
Power Supply
TROUBLESHOOTING
- If the driver is humming, lights are not turning on or are flickering:
•
Check that this driver is not overloaded or overheated. The automatic breaker will trip and recover once the external cause has been corrected.
•
Make sure the polarity of the AC line wires match the polarity of the channels on the Power Input Terminal.
•
If the driver is powered, check the polarity on the Power Output Terminal. Make sure you have matched the markings on the LED strip to the
channels on the driver.
•
Check that your dimmer is on the compatible dimmer list.
•
Make sure all the connections (solderless connectors, solder joints, terminal blocks, and spliced wires) are secure and making correct contact.
•
Make sure the power requirements are being met, 100-277VAC input and 12-24VDC output (depending on the driver), check these with a
multimeter.
•
If the driver isn’t providing the adequate voltage ensure proper size gauge wire is installed by factoring voltage drop and amperage rating. If
the voltage at the end of the wire is 10.5V or less for a 12V unit and less than 21V for a 24V unit, we recommend installing a heavier gauge wire
between the driver and the LED load.
•
Check that the wire connections are accurate by referring to the wiring diagrams provided.
•
Check that your installation has not tripped the circuit breaker at the main service panel of the building. If this occurred reset the breaker. If it
trips again, it is possible that there is an electrical short/defective component or a connection issue on the AC side of the driver.
V.2019.08.29
ZRK-EMLV2-200W-XXDC
8
page
support@FlexfireLEDs.com
925-273-9080 opt 2
User Guide
•
ZURIK
®
EMLV LED Driver 200W
