Zuchetti 1L2DL, User Manual

Page: 19 / 40

19 User’s manual
EN
6. Fasten the charging station (N) to the ground with the pegs (P).
If necessary, secure the charging station with screw anchors
(Q).
pegs (P)
screw anchors (Q)
charging station (N)
7. Connect the power cord (E) of the charging station (N) to the
power supply unit (A)(B).
8. Connect the plug of the power supply unit (A) to the electrical
outlet.
9. If the LED of the transmitter flashes, the connection is correct.
Otherwise, find the anomaly (see “Troubleshooting Guide”).
10. Replace the protection (L).
current power
supply unit (A)
power cord (E)
Perimeter
wire
charging
station (N)
transmitter (B)
H. min.
160 cm
(63.00 ")
protection
(L)
batteRy chaRGInG on fIRst Use
1. Place the robot inside the charging station.
2. Press the “ON” key.
3. After a few seconds, the “CHARGING” message will appear on
the display. Afterwards, the display will show other information
in rotation such as:
-
day of the week, Date
-
programmed working times
-
working time, total working time
-
battery information
4. Press the “PLAY/PAUSE” key. The “PAUSE” function appears
on the display. The batteries start the charging cycle.
5. At the end of charging, the robot can be programmed for initial
start-up (see “Programming Mode”).
“START/PAUSE” KEY
“ON” KEY
Important
On first use, always charge the batteries for at least 4 hours.