18
User’s manual
EN
Joining of the perimeter wire
Important
a buried wire or a wire laid on the ground can be
joined to other wires having the same characteristics
(see figure). When joining the two wires, make sure
to use self-sticking tape (for example, 3m scotch
23). do not use insulating tape or any other type of
joining devices (wire terminals, clamps, etc.).
3
5
6
4
1
2
InstallatIon of the chaRGInG statIon and PoWeR sUPPly UnIt
Warning – caution
before carrying out any operations, disconnect the
robot from the mains power.
Position the power supply unit in an area that
cannot be reached by children. for example, at a
height above 160 cm (63 ").
protection
(L)
current power supply unit
(A)
transmitter
(B)
H. min.
160 cm
(63.00 ")
1. Install the power supply unit (A)(B).
2. Remove the protection (L).
3. Position the charging station in the predefined area.
4. Insert the perimeter wire (M) under the charging station.
5. Connect the two ends of the wire to the terminals of the
charging station.
red terminal
black terminal
perimeter wire (M)
Summary of Contents for 1L2DL
Page 40: ...40 User s manual EN...
