
Switch functions
Standard connection diagram for the detector: the detector can be
switched to the various modes via the breaker switch. Please note that
for this function, the rhythm of the pulse and break times must be
correctly adjusted. If a switch is used that is not directly next to the
detector, cable interferences may interrupt this function, which is
dependent on the installation, although there is no guarantee.
If the functionality of the switches is faulty, a capacitor/RC element can
be switched in parallel before the detector (from L to N).
Switch functions (by interrupting the detector's incoming phase
L, On/Off)
Press once
(briefly press once for one second) and the device is
switched to automatic mode (relay 1 and 2), all other previously
selected modes are terminated or switched off even is they were
previously activated with the control pad.
Warning: If Time 1 is set to pulse, then ON, holiday and party mode
cannot be activated!
Press once
(interruption of approx. two seconds): Light on relay 1
switches on for the amount of time set under the "Time 1 controller"
and then switches to automatic mode. Relay 2 is not included in this
function.
Press twice
(two interruptions within two seconds): Party mode and
the light is permanently switched on for six hours or until dusk. Relay 2
is not included in this function.
Press three times
(three interruptions within three seconds): Holiday
mode and the light is permanently switched on for the preset "DUSK
TIME" (OFF; two to eight hours) once the brightness value falls below
the value set with the "LUX" controller. It then switches to automatic
mode until the next day or the next time it starts to get dark.
Relay 2 is not included in this function.
This function is repeated daily until it is deactivated.
When selecting holiday mode via the control pad, it is set for 3.5 hours
9