Vario Press 100
Operations Manual
VP_0206E
42
Note: See the “TIMED PRESS” section of this manual (page 30) for further information on
RE-PRESS and TIMED PRESS
.
To access the functions with a password number do the following:
1.
Press the
“Special Functions”
button
2.
Turn the select knob counter clockwise to select
“Calibrate Oven”
3.
Press the
“Next”
button
4.
Turn the select knob to select the numerical password needed
5.
Press the “Next” button and select the appropriate setting
6.
Press “Next” button to accept this setting
Selecting and Running a Manual Pressing Program
The
Vario Press 100
furnace provides a manual program to add temperature and time to a piece of
work that has been determined to be under fired.
Procedure:
1.
Press
the
“Run Program”
button. Turn the
Silver Select Knob
to program number
99.
Program number
99
is the
manual add temperature
program.
2.
Press
the
“Start Program”
button to begin.
3.
The display will read as shown below. Turn the
Silver Select Knob
to the final temperature for
this program.
4.
The
Hold Time
will be displayed as shown below. Turn the
Silver Select Knob
to select the
time you wish to hold the porcelain at the final temperature.
5.
Press
the
“Next”
button to continue.
6.
“COOL TIME” will be displayed. Turn the
Silver Select Knob
to the desired cool time. This is
the time the furnace uses to bring the table to its fully down position. The table will be lowered in
steps evenly spaced during the cool time.
7.
Press the
“Next”
button to continue.
The table will rise to the fully up position and the program will run in the same manner as a normal
porcelain firing cycle. All of the normal displays are available while running a manual program.
SELECT PROGRAM?
99 MAN – ADD TEMP
FINAL TEMP XXXC
HOLD TIME
Summary of Contents for Vario Press 100
