ZTW 4045201, User Manual

Page: 2 / 12

1
Thank you for purchasing ZTW Gecko Series Brushless
Electronic Speed Controllers (ESC).
High power systems for RC model can be very dangerous and we strongly suggest
that you read this manual carefully. ZTW Model have no control over the use,
installation, application, or maintenance of these products, thus no liability shall be
assumed nor accepted for any damages, losses of costs resulting from the use of this
item. Any claims arising from the operating, failure or malfunctioning etc. will be
denied. We assume no liability for personal injury, property damage or
consequential damages resulting from our product or our workmanship. As far as is
legally permitted, the obligation for compensation is limited to the invoice amount
of the product in question.
The ZTW ESC's high power BEC has been specifically designed for extreme
aerobatics and therefore has the capability to support the higher momentary peak
demand loads to eliminate the possibility of unwanted shutdowns, and is also
capable of supporting continuous simultaneous multiple servo operations typically
found in CCPM equipped hardcore 3D E-helicopters.
Wires Connection:
The speed controller can be connected to the motor by soldering directly or with high
quality connectors. Always use new connectors, which should be soldered carefully
to the cables and insulated with heat shrink tube. The maximum length of the battery
pack wires shall be within 6 inches.
Solder controller to the motor wires.
Solder appropriate connectors to the battery wires.
Insulate all solder connectors with heat shrink tubes.
Plug the “JR” connector into the receiver throttle channel.
Controller Red and Black wires connects to battery pack Red and Black wires
respectively.