ZTW 4045201 User Manual Download Page 6

Page: 6 / 12

would be definitely changed, the lost RPM will be detected and compensated
automatically by the ESC that makes sure to keep the RPM at the same speed. (Note:
This function is only for High KV motor)

Note 1:

If the throttle is cut off after starting less 3 Seconds, then the next start will be

as normal start. If the throttle is cut off after starting more than 3 Seconds, the next start
will be as soft start.

Note 2:

Once the Governor Mode is enabled, the ESC's Brake and Low Voltage Cutoff

Type settings will automatically be reset to Brake Off and Reduce Power respectively,
regardless of what settings they were previously set.

Note 3:

Lower 50,000 turns is considered as Low KV motor,

100,000-200,000 turns is considered as High KV motor.
Formula: Pole's qty of motor x KV value x Voltage= Motor turns
For example: we test 8 pole motor 1040KV with 6S Lipo, its turns will be
8x1040KVx25v=208,000 turns, so you can choose Governor Mode 2.

8. Motor Rotation: Forward/ Reverse

In most cases motor rotation is usually reversed by swapping two motor wires.
However, in cases where the motor cables have been directly soldered the ESC cables,
motor rotation can be reversed by changing the value of setting on the ESC.

9. Start up Strength

Low

(10%-15%-20%) Sets ESC start up strength for the motors which needs low start

up current
*

Mid

(25%-30%-35%) Sets ESC start up strength for the motors which needs mid

start up current
*

High

(40%-45%-50%) Sets ESC start up strength for the motors which needs high

start up current

10. Low Voltage Cut Off Type: Reduce Power / Cut Off Power
* Reduce Power

– ESC reduces motor power when the pre-set Low Voltage Protection

Threshold value is reached. (Recommended)

* Cut Off Power

– ESC instantly cuts motor power when the pre-set Low Voltage

Protection Threshold value is reached.

THE PROCEDURE AND INSTRUCTION OF THE PROGRAMMING BY
TRANSMITTER

1. ENTERING THE PROGRAMMING MODE
2. SELECTING THE PROGRAMMABLE ITEM
3. SELECTING THE DESIRED VALUE OF THE PROGRAMMABLE ITEM
4. DISCONNECTING THE BATTERY PACK