ZXSDR BS8908 G060 User Manual
3.
Remove the protective cap of the AISG debugging interface, connect end A of the
AISG control cable to the debugging interface (AISG) of BS8908, and fasten the screw
at the interface.
4.
Connect end B of the AISG control cable to the control interface of the electrical
antenna.
– End of Steps –
5.7.10 Installing GPS Cable
Prerequisites
Wear the antistatic wrist strap.
The BS8908 cabinet is installed and fixed.
Context
The GPS cable provides physical transmission for the GPS signal between the BS8908
system and the GPS antenna.
One end of the GPS cable is N-J connector, and the other end of the cable is SMA
connector. The cable is the 50
Ω
coaxial cable.
Steps
1.
Connect end A of the GPS cable to the GPS cable interface (GPS) of the BS8908
cabinet.
2.
Connect end B of the GPS cable to the GPS antenna feeder.
3.
Perform lightning-protection and waterproof handling for the GPS cable.
4.
Fix the GPS cable.
– End of Steps –
5.7.11 Installing Antenna Feeder Jumper
Context
The antenna feeder jumper is the cable connecting the main feeder and the antenna feeder
interface of the BS8908 cabinet. Usually, the antenna feeder jumper is installed after the
main feeder is installed.
Usually, the RF jumper is made of 1/2" jumper with a length of 2 m. The RF jumper can
also be made according to actual requirement.
shows the installation position of the antenna feeder jumper.
5-42
SJ-20101104174421-001|20110425(R1.1)
ZTE Proprietary and Confidential
Summary of Contents for ZXSDR BS8908 G060
Page 5: ...Glossary V III ...
Page 6: ...IV ...
