ZXSDR BS8908 G060 User Manual
3.
Remove the protective cap of the E1 (E1/T1) interface, connect end A of the E1 cable
to the E1 (E1/T1) interface, and fasten the screw at the interface.
4.
For the E1 cable, connect end B to the cable trough according to
– End of Steps –
5.7.6 Installing Abis Ethernet Cable
Prerequisites
Wear the antistatic wrist strap.
The BS8908 cabinet is installed and fixed.
Context
The Abis Ethernet cable provides physical transmission for Ethernet between iBSC and
BS8908.
The Abis Ethernet cable is made of outdoor super category-5 shielded network cable.
The connector is plastic 8P8C straight-cable crimping shielded connector (with the hook
protection).
shows its appearance.
Figure 5-33 Abis Ethernet Cable
1.
Waterproof cap
2.
Fixing block
Steps
1.
Bind the cable tie at the bottom of the cable rack corresponding to the Abis interface.
2.
Make the Abis Ethernet cable pass the cable tie, tighten it to the cable rack, and fasten
the cable tie.
3.
Remove the protective cap of the corresponding jack. Remove the waterproof cap
from end A of the Abis Ethernet cable.
4.
Connect end A of the Abis Ethernet cable to the external interface of BS8908, and
insert the waterproof connector.
5.
Connect end B of the Abis Ethernet cable to the switch.
6.
Paste labels at the two ends of the Abis Ethernet cable.
– End of Steps –
5-38
SJ-20101104174421-001|20110425(R1.1)
ZTE Proprietary and Confidential
Summary of Contents for ZXSDR BS8908 G060
Page 5: ...Glossary V III ...
Page 6: ...IV ...
