Zte ZXR10 T1200, User Manual

Page: 47 / 83

Chapter 6 OSPFv3 Configuration
St-
ep Command Function
6
ZXR10(config-router)#
default-metric < metric-value > This sets the default metric
value for the OSPFv3 protocol.
The range is from
1–16777214. The default
value is 20.
7
ZXR10(config-router)#
passive-interface < ifname > This disables the interface
where OSPFv3 is enabled to
transmit OSPFv3 packets.
8
ZXR10(config-router)#
redistribute < protocol >[
metric < metric-value >][ metric-ttype <
type >][ route-maap < name >]
This redistributes routes of
another protocol into OSPFv3
protocol.
9
ZXR10(config-router)#
timers spf < delay >< holdtime > This sets interval of OPSFv3
calculating routes.
Result: The protocol attributes have been configured.
Configuring OSPFv3
Maintenance and Diagnosis
Comparing to RIPng, OSPFv3 is more complicated. A fault phe-
nomena has many fault reasons. Therefore, the maintenance and
diagnosis of OSPFv3 is more difficult.
To maintain and diagnose OSPFv3, use the following commands.
Command Function
ZXR10#
show ipv6 ospf < tag > This shows an OSPFv3 instance.
ZXR10#
show ipv6 ospf database This shows the database
information about OSPFv3
instance.
ZXR10#
show ipv6 ospf interface [< interface-name >] This shows the interface
information about OSPFv3
instance.
ZXR10#
show ipv6 ospf neighbor This shows the neighbor
information about OSPFv3
instance.
ZXR10#
show ipv6 ospf route This shows the route information
calculated by OSPFv3 instance.
ZXR10#
show ipv6 ospf topology This shows the topology
information about OSPFv3
instance.
Confidential and Proprietary Information of ZTE CORPORATION 39