Zte ZXR10 T1200, User Manual

Page: 45 / 83

Chapter 6 OSPFv3 Configuration
St-
ep Command Function
3
ZXR10(config)#
interface < interface-name > This enters interface
configuration mode.
4
ZXR10(config-if)#
ipv6 ospf < process-id > area
< area-id >[ instance-id < 0-255 >]
This configures an interface
into OSPFv3.
Result: The OSPFv3 has been enabled.
Configuring OSPFv3 Interface
Attributes
To configure interface attributes, perform the following steps.
St-
ep Command Function
1
ZXR10(config)#
interface < interface-name > This enters into interface
configuration mode.
ZXR10(config-if)#
ipv6 ospf hello-interval
< interval >[ instance < 0–255 >]
This specifies interval of
sending Hello packets on an
interface.
The unit is second. The range
is from 1 to 65535.
The default value for point
to point and broadcast
interfaces is 10 seconds.
The default value of
non—broadcast and
point-to-multipoint interface
is 30 seconds.
ZXR10(config-if)#
ipv6 ospf retransmit-interval
< interval >[ instance < 0–255 >]
This specifies the time
interval at which an interface
retransmits an LSA.
The unit is second. The range
is from 1 to 65535.
The default value is 5
seconds.
ZXR10(config-if)#
ipv6 ospf transmit-delay
< interval >[ instance < 0–255 >]
This specifies the delay after
which an interface transmits
a link state update packet.
The unit is second. The range
is from 1 to 65535.
The default value is 1 second.
ZXR10(config-if)#
ipv6 ospf dead-interval
< interval >[ instance < 0–255 >]
This specifies the aging time
of neighbors on an interface.
The unit is second. The range
is from 1 to 65535.
2
Confidential and Proprietary Information of ZTE CORPORATION 37