5
Quick change system for SPRINT Series
1.2
Preparations
Please read the description of the procedure carefully through. The description
contains information which you have to be aware of before the installation.
Subassembly of the horizontal barrel adjuster
Screw one of the nuts on the clamping
screw.
The end position of the nut should
be approximately 3-4 mm above the
screw head.
Slide one of the guide washers on the
screw. The guides of the washer should
be located on the far side of the head
of the clamping screw.
Carry out the assembly with the second
clamping screw as well.
Fig. 1: Clamping screw with nut and washer
Insert the prepared clamping screw
from the bottom of the inclusion of the
horizontal clamping fixture.
Slide the second guide washer above
the clamping fixture adaptor from the
top on the clamping screw.
The guides of the washer must be in
the direction of the clamping fixture
adaptor.
Fig. 2:
Clamping fixture adaptor
!
Summary of Contents for SPRINT Series
Page 2: ......
Page 22: ...22 Quick change system for SPRINT Series...
