Create a space to install your hob , following the dimensions indicated on figure.
*100 mm from edge of cooker to combustible materials.
*
7
0
0
mm underside of overhead cupboards, shelving
* 650mm underside of overhead exhaust fans.
This appliance must be installed according to the manufacturers installation
instructions, local building regulations, gas authority codes and electrical wiring instructions.
.
Changing the Gas Inlet
:
The gas feeding manifold protruding from the back of the hob must be visible completely,
any means connection (nut,hose etc.)must be placed with attention to avoid any contact
with parts that will heat up. It is highly recommended to block the access to pipe connection,
while the cooker is in use or when the gas supply is open.
During the gas connection process, the pipe of the appliance should be kept
stationary, while the connected part (mechanical, LPG or NG nut) is fixed.Always use the
seals supplied in the spare set between the connection ‘A’ for flexible hose connection.
For connection of methane type gases (NG),
6
* Use B type connection in Spain, Italy, Portugal, Greece, France and Algeria for use with
flexible hose conection.
* Use C type connection in Letonia and Luxemburg for mechanical connection.
This connection may also be optionally used in some areas in France, Algeria, Spain,
Portugal and Italy.
* Use C type connection in Germany and Belgium with an additional ISO7/ISO228 adapter
and Netherlands with an additional Besca adapter, supplied in the spare set. An example
of usage is shown in E.
