Bgate-GT10-D24-N22-P
Zoomnet Confidential Proprietary
@ 2013 Zoomnet Corporation. All rights reserved
18
5
）
Security:
Click
<Edit>
button then select authentication method, encryption algorithm and
secret key
6
）
APPLY:
After finish setting, click
<APPLY>
button to take the new configuration go into
effect
5.3 Modify Wireless Parameters
Click
[Wireless Settings/Advanced settings]
, access to the UI, and then choose the
parameters for 2.4G and 5.8G wireless network adapter.
Mode:
2.4G network could select 11B, 11G, 11NGHT20, 11NGHT40PLUS and
11NGHT40MINUS modes. 5.8G network could select 11A, 11NAH T20, 11NAHT40PLUS,
11NAHT40MINUS.
Channel:
2.4G frequency band can choose 1~11 channels, 5.8G frequency band can
choose 149~165 channels. Default selection is Atuo.
Speed:
It can set as Auto or MCS0~MCS15, default selection is Auto.
MTU:
Set the maximum fragmentation length. When data package is larger than this value it
will be fragmented. Its unit is byte, range is 256~2346, and the default value is 2346.
RTS Threshold:
Its unit is byte, range is 0~2347, 0 means disable this threshold and the
default value is 2346. When data frame is larger than this value, RTS/CTS protection
mechanism will be enabled.
Ack timeout control:
Its unit is
μ
s, range is 0~256, and the default value is 64.
Beacon Interval:
Its unit is TU, range is 100~1000, and the default value is 100.
Packet aggregation:
Enable this functionto activate MAPDU mechanism
Short GI:
By activating Short GI, data volume can be increased.
Wireless user isolation:
When enable this item it will prevent wireless users communicate
with each other.
Txpower:
Set Txpower for AP channel.
RS IP address:
Fill in the IP address of RS server
AS IP address:
Fill in the IP address of AS server
5.4 Check and Modify Parameters
Step1. Enter the CLI interface of AP device by serial port or telnet tool.
Step2. Run the command of iwpriv interface mode desired_mode. “interface” in this
command is the name of port, and “desired_mode” is a anticipant mode, which can be
selected from AUTO, 11A, 11NAHT20, 11NAHT40PLUS, 11NAHT40MINUS,
11B,1G,1NGHT20, 11NGHT40PLUS, and 11NGHT40MINUS.
Step3. Use command iwpriv interface get_mode to check the VAP mode.
