If you are using a non Windows computer or other device that supports
WPS
Please refer to the instructions for your device for more information on using WPS. The
directions below should work for most users.
1
Press the
WPS
LED pushbutton on the front panel of the router for at least 3
seconds. The WPS LED should blink orange.
2
Within 2 minutes (before the WPS LED orange light turns off), press the WPS button
on the device that you’re linking wirelessly to the modem/router. The button may be a
physical pushbutton on the device or a button on a page of the device’s wireless
network configuration menus.
3
Congratulations! You should now have a secure connection between your Cable
Modem/Router and a device. Now is a good time to check that your device’s Internet
connection is working. Open your browser and go to a familiar Web site. If you are
able to connect, continue with the next step below.
If you are not able to connect to the Internet, please see
Appendix A:
Troubleshooting Tips
.
4
If you have other devices whose WPS security you need to set, repeat steps 1
through 3 for each device. When they are finished, the basic setup for these local
wireless devices should be complete
.
27
Summary of Contents for 5363
