Zontes VX 350, Manual

Page: 12 / 50

10
TFT Instrument
Tire pressure function description:
1. Tire pressure and temperature alarm
When the instrument receives that the tire pressure temperature information from the sensor
exceeds the limit value, the instrument interface displays the corresponding tire pressure temperature
alarm text, and the tire pressure indicator flashes (1 Hz).
2. Low voltage alarm
When the tire pressure sensor detects that the battery voltage value is lower than 2.6V, the
interface shows that the sensor battery is low, the alarm will not disappear until the new sensor is re-
matched, and the tire pressure indicator flashes (1Hz).
3. Air leakage alarm
When the sensor detects the change of tire pressure (decompression), it will prompt a leak alarm
and the tire pressure indicator will flash (1 Hz).
4. Unlearned alarm
When the meter does not match the sensor and the tire pressure setting interface displays "Not
Learned", the main interface displays "Not Learned Alarm" and the tire pressure indicator flashes (1
Hz).
5. Sensor loss alarm
When the signal from the sensor is not received, the meter shows that the sensor is missing and
the tire pressure indicator flashes (1 Hz).
Remove alarm: The alarm disappears after receiving valid data.
6. Sensor failure alarm
When the meter receives the sensor chip fault information, the interface displays the sensor fault
alarm and the tire pressure indicator flashes (1 Hz). At this time, the sensor needs to be replaced,
otherwise the tire pressure information cannot be displayed normally.
7. System failure alarm
When the chip that receives the signal inside the instrument fails, the instrument interface displays
a system failure alarm and the tire pressure indicator flashes. At this time, the instrument needs to be
replaced, otherwise the tire pressure information cannot be displayed normally.
8. Learning matching function.
① First adjust the motorcycle meter to the learning mode, that is: power on the meter → enter the
menu → tire pressure setting interface → operate the instrument button to set the front (rear) wheel to
"learning..." and wait for the tire pressure sensor to learn information.
② Continue to inflate or deflate the corresponding front wheel or rear wheel until "Success" is
displayed.
③ When the meter receives the matching signal from the tire pressure sensor, after the match
is successful, the text "Learning..." on the tire pressure setting interface will be displayed as
"success". At this time, the meter can receive the tire pressure temperature information of the
sensor.
If the learning is unsuccessful, you need to repeat the above operation and increase the time of
inflation and deflation.