ZSI-330 User Manual
Issue 01
Page 10 of 30
Telemetry
Receiver
For each receiver 1 – 16 the telemetry can be setup as follows
Port
Select the port used to transmit telemetry.
ZVR
port would normally be used unless the receivers are connected
through a separate site controller.
ZoneVu
port is used to route telemetry through the site controller (not
currently supported).
Default =
ZVR
Polled
Tick this box if the receiver is to be polled for alarm and status information, where supported
Default =
Off
ZVR port
Settings for all receivers connected on the ZVR port
Baud rate
Z
S
I
-
3
3
0
Sets the communication speed for the receivers. Available speeds:
1200, 2400, 4800, 9600, 19200, 38400,
57600, 12800
.
Default =
9600
MEYERTECH LIMITED
