Prepare to print - Level the hotbed
1. Power on the 3d printer and then do
“Prepare>>Auto Home>>Home All”
on control panel, wait the
hotend go to the HOME (origin) position.
2. Watch the nozzle, tighten the hand nuts under the bed to move down or loosen these nuts to move up
the bed (
Fig 1),
let the nozzle is higher than the bed about 1~2mm.
3. Do
“Prepare>> Bed leveling>> Point 1(2/3/4)”
on control panel(
Fig 2)
, the nozzle will go to the
corners of the bed, adjust the hand nuts under the hotbed and let the nozzle almost touch the hotbed
(
Fig 3)
. Continue to do the next point until all of the 4 corners has been leveled.
4. Repeat step 3 (recommend to do 3 rounds at least), until all of the four corners at the same height.
Fig 1
Fig 2
Fig 3
20
Summary of Contents for Z8PM4 Pro
Page 1: ...Model Z8PM3 4 Pro User Guide...
Page 15: ...Wiring Block...