•
Orient the Canister Set so that the unit with the wake-up fin is on the west side of the
rack (with the wake-up fin underneath the rack). The transfer tube is designed to enter
from the bottom (underside) of each canister.
•
Remove the 1/4” hex nuts and square washers from the top of the Canister Mounting
Tabs and open up the strap.
•
Align the Canister as necessary in order to find a place for the strap clamps. The
Canisters can usually be installed so that they are centered with respect to the Cross
Arms. If the Canisters must be offset, this will not affect the function of the rack.
•
Re-install the strap, square washer and 1/4” hex nut.
•
Tighten the 1/4” hardware to no more than 75 in-lbs (6 ft-lbs).
•
Repeat the procedure for remaining Canister clamps.
Installing Shadow Plates
•
Each canister must
have a Shadow Plate.
The plate that has a
Zomeworks sticker can
be installed on either
side of the rack.
•
Using the 1/4” round-
head bolts, lock
washers, and wide flat
washers provided,
install as shown.
