C
HAPTER
2 S
ET
U
P
2-2
www.zoll.com
9650-0535-01 Rev. C
The charger rests on four rubber feet when you place it on a table top or counter.
Figure 2-2
SurePower Charger Station
Bottom View
Caution
Do not remove the rubber feet from the charger base. The rubber feet provide a space between
the charger base and the work surface that is necessary for adequate heat dissipation.
Powering on the Charger
To power on the charger, plug the AC cord attached to the rear of the charger into live AC
mains.
Use
only
the AC cord that ZOLL Medical Corporation provides.
Note:
There is no power switch on the
SurePower Charger Station
-- the unit is powered on at
all times when it is plugged in and AC power is available.
Warning!
Always inspect the AC cord before use. Do not use the AC cord if it is defective -- for
example, the cord’s insulation is cracked or the cord is severely kinked.
Self Test at Power On
When you connect to the AC mains without batteries in the charging bays, the charger performs
a self-test which briefly lights
all
LEDs and then sounds an audible alarm tone. After a few
seconds all LEDs, except the
Power
LED in the middle of the control panel, will go out.
Should the charger detect a fault with its operation, it will light the
Fault
LED for the charger
bay or bays affected by this fault.
Note:
If batteries are installed in the charging bays when you power on the
SurePower
Charger Station
, the charger performs only a partial self test; the
SurePower Charger
Station
performs a full self test when you remove the batteries from the charger bays.
Summary of Contents for SurePower
Page 1: ...SurePower Charger Station Operator s Guide 9650 0535 01 Rev C...
Page 22: ...CHAPTER 2 SET UP 2 4 www zoll com 9650 0535 01 Rev C...
Page 32: ...CHAPTER 3 OPERATION 3 10 www zoll com 9650 0535 01 Rev C...
Page 38: ...CHAPTER 5 USING ZOLL RECHARGABLE BATTERIES EFFECTIVELY 5 4 www zoll com 9650 0535 01 Rev C...
