15
the self-Cleaning program. Same as above explanation, the water pump runs for 8
minutes and stops for 3 minutes, one cycle, again one cycle. The total duration time is 30
minutes for one self-cleaning program.
During this process, the “CLEAN
”
light will always be on during this period, and the digit
window will indicate the left time. Through this process, It will rinse the water dividing pipe,
evaporator, water pump, silicone pipe, and water tank, etc.
9. After one self-cleaning program complete, then pull out the drain pipe of the water tank,
drain the cleaning solution down to the lower ice storage bin, also shake the unit slightly to
drain out all of the water completely. Then install back the drain pipe to the water tank slot
tightly.
10. Repeat the step 8-9 again for 2 times.
11. Following the above program to clean the ice storage bin.
12. Then this special cleaning program finish, you can return to the regular ice making
mode. And suggest to discard the first batch of ice cube.
6) Cleaning Suggestion
1. DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself per each
day. At the end of every day, rinse the ice shovel and wipe the both sides of the door with a
clean cloth.
2. SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the
evaporator are to be cleaned by yourself semi-monthly according to interior cleaning
program.
3. SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water
tank, door, evaporator, water pump, silicone tube, water dividing pipe, etc.
should be
cleaned by Using Nu-Calgon Nickle Safe Ice-machine Cleaner per each 6 months.
They should be cleaned by the serviceman according to ice making assembly
system cleaning program.
7-NORMAL TROUBLE SHOOTING
a) Ambient temp sensor breakdown----- Display E1 in digital window.
b) Suction tube temp sensor----Display E2 in digital window.
c) -Magnetic control switch cutoff----”Full” light will be on when plugging on or just
turning on the unit. And it will delete the breakdown display if this switch is electric
shorted.
d) During the ice making process, press the “ON/OFF” button for more than 5
seconds, the unit start to enter the ice harvest program. And after the ice harvest
program, it continue to enter the ice making process.
Problem
Possible Cause
Solution
