Pattern selection interface
Template machine - Touch screen E2
15
Under the interface of spindle Angle installation and test, remove
the spindle motor, rotate the hand wheel to swing the needle rod
to the highest point, reinstall the spindle motor, confirm that the
electrical value displayed is within 0-30 ° or 330-360 °, and then
press ok
. Otherwise, remove the spindle and repeat the
above operation.
2.2.4 Speed test
In the [detection] interface, click "speed test"
to enter
the [speed test] interface.
+
Display the current spindle motor "target speed" and
"actual speed"
②
The spindle motor speed can be set by clicking "speed
minus"
and "speed plus"
. After clicking "start"
, the spindle motor will run at the set speed. At this
point, the actual measured speed will be displayed in the "actual
speed" column.
Click stop
, and the machine stops running.
