2
© Copyright 2014 Zoeller Co. All rights reserved.
Manufacturer warrants, to the purchaser and subsequent owner during
the warranty period, every new product to be free from defects in material
and workmanship under normal use and service, when properly used and
maintained, for a period of one year from date of purchase by the end user, or
18 months from date of original manufacture of the product, whichever comes
first. Parts that fail within the warranty period, one year from date of purchase
by the end user, or 18 months from the date of original manufacture of the
product, whichever comes first, that inspections determine to be defective
in material or workmanship, will be repaired, replaced or remanufactured
at Manufacturer's option, provided however, that by so doing we will not be
obligated to replace an entire assembly, the entire mechanism or the complete
unit. No allowance will be made for shipping charges, damages, labor or
other charges that may occur due to product failure, repair or replacement.
This warranty does not apply to and there shall be no warranty for any
material or product that has been disassembled without prior approval
of Manufacturer, subjected to misuse, misapplication, neglect, alteration,
accident or uncontrolled act of nature; that has not been installed, operated
or maintained in accordance with Manufacturer's installation instructions;
that has been exposed to outside substances including but not limited to
the following: sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon
derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive
substances, wash towels or any other abusive entity, etc. in all pumping
applications. The warranty set out in the paragraph above is in lieu of
all other warranties expressed or implied; and we do not authorize any
representative or other person to assume for us any other liability in
connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211
USA, Attention: Customer Support Department to obtain any needed repair
or replacement of part(s) or additional information pertaining to our warranty.
MaNUfaCTURER EXpRESSLy DISCLaIMS LIaBILITy fOR SpECIaL,
CONSEQUENTIaL OR INCIDENTaL DaMagES OR BREaCH Of
EXpRESSED OR IMpLIED WaRRaNTy; aND aNy IMpLIED WaRRaNTy
Of fITNESS fOR a paRTICULaR pURpOSE aND Of MERCHaNTaBILITy
SHaLL BE LIMITED TO THE DURaTION Of THE EXpRESSED WaRRaNTy.
Some jurisdictions do not allow limitations on the duration of an implied
warranty, so the above limitation may not apply to you. Some jurisdictions do
not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights and you may also have other
rights which vary from jurisdiction to jurisdiction.
LIMITED WARRANTY
HELpfUL HINTS fOR EaSy INSTaLLaTION
1. Read all instructions before beginning installation.
2. Be sure the floor is level within 3 mm (1/8").
3. Install vent pipe seal with flange side of seal on outside of lid.
4. Use soapy water to lubricate all seals to aid installation.
5. Install rubber coupling/union in vent line to aid disassembly.
6. Do not over torque toilet mounting screws.
7. Do not use an automatic plumbing vent device.
8. Obtain model number and date code, and record information in the
space provided on the front of this manual. Refer to this information
when calling the factory.
DO’S aND DON'T’S fOR INSTaLLINg a UNIT
1. DO read all installation material with the unit.
2. DO inspect unit for any visible damage caused by shipping. Contact
dealer if unit appears to be damaged.
DO’S aND DON'T’S,
continued
3. DO clean all visible debris from the unit.
4. DO always disconnect pump from power source before handling.
DO always connect to a separately protected and properly grounded
ground fault protected circuit. DO NOT ever cut, splice or damage
power cord. DO NOT carry or lift pump by its power cord. DO NOT
use an extension cord.
5. DO install a ball or gate valve and a union in the discharge line
downstream of the check valve.
6. DO test pump immediately after installation to be sure that the system
is working properly.
7. DO review all applicable local and national codes and verify that the
installation conforms to each of them.
8. We DO NOT recommend this product be connected to utilities other than
those found in a normal bathroom application. Washing machines and
dishwashers are examples of equipment that we DO NOT recommend.
9. DO inspect and test system for proper operations at least every 3 months.
TYPICAL PIPING CONFIGURATIONS
SK2587
Installation may not be
exactly as shown. Refer
to step 1 on page 5 for
piping details.
2.4 m (8')
CEILING *
2.1 m (7')
CEILING *
20.32 cm (8") min.
CHECK VALVE
P/N 30-0181
* Ceiling heights shown for reference only.
NOTE: all installations must
comply with all applicable
governing codes.
