3
© Copyright 2015 Zoeller
®
Co. All rights reserved.
SAFETY INFORMATION
DANGER:
1. Always disconnect power source before performing any work on
or near the motor or its connected load. If the power disconnect
point is out-of-sight, lock it in the open position and tag it to
prevent unexpected application of power. Failure to do so could
result in fatal electrical shock.
2. Do not handle the pump with wet hands or when standing in
water as fatal electrical shock could occur. Disconnect main
power before handling unit for ANY REASON!
3. RISK OF ELECTRIC SHOCK. These pumps have not been
investigated for use in swimming pool areas.
WARNING:
1. Follow all local electrical and safety codes, as well as the
National Electrical Code (NEC) and the Occupational Safety and
Health Act (OSHA).
2. Replace damaged or worn wiring cord immediately.
3. Do not kink power cable and never allow the cable to come in
contact with oil, grease, hot surfaces, or chemicals.
4. Wire motor to correct supply voltage - see motor nameplate and
wiring diagrams and check voltage of power supply.
5. Unit must be securely and adequately electrically grounded.
This can be accomplished by wiring the unit to a ground
metal-clad raceway system or by using a separate ground wire
connected to the bare metal of the motor frame or other suitable
means.
6. Hazardous Pressure! Install pressure relief valve in discharge
pipe. Release all pressure on system before working on any
component.
7.
Do not use to pump flammable or explosive fluids
such as
gasoline, fuel oil, kerosene, etc. Do not use in flammable and/or
explosive atmospheres.
CAUTION:
1. Protect the power cable from coming in contact with sharp
objects.
2. Be careful when touching the exterior of an operating motor - It
may be hot enough to be painful or cause injury.
3. Make certain that the power source conforms to the
requirements of your equipment.
4. Do not run pump dry.
5. Pump and plumbing must be full of water before startup.
6. Do not pump water which contains sand, mud, silt, or debris
NOTE: Pumps with the “UL” Mark and pumps with the “US” mark
are tested to UL Standard UL778.CSA certified pumps are certified
to CSA Standard C22.2 No. 108. (CUS)
MOTOR DATA CHART
HP
Phase
Volts
Code Letter
Max Amps
Locked Rotor Amps
1/2
1
115 or 230
K
13.0/6.5
36.0/18.0
1
1
115 or 230
L
18.0/9.0
78.0/39.0
IMPORTANT:
This jet pump is wired for either 115V or 230V. The label on the pump will state whether pump is pre-wired for
115V or 230V. To change pump voltage, see pump label diagram.
