Zoeller 910, Installation Instructions Manual

Page: 15 / 38

HOW TO INSTALL
JACKEL’S 4" DWV SNAP-IN HUB*
Note:
The Snap-in hub is made from plastic rubber and is designed for use
with 4" DWV ABS Schedule 40 pipe and 4" PVC Schedule 40 pipe (4-1/2"
O.D.) and has an operating range from -28 °C (-20 °F) to 50 °C (120 °F).
(A) Step 1 Hold Snap-in hub in upward position in right hand so that the
ARROW and TOP markings are visible.
Step 2
With right hand push bottom track, which is molded in the Snap-
in hub, into the bottom edge of tank hole.
Step 3 Hole in place with left hand inside tank. Then squeeze hub
outside of tank into oval shape and push into hole, pulling with
left hand and fitting rest of hole edge into the track.
Step 4 If hub appears out of round, run fingers around inside hub seal to
make sure it has a tight fit. Examine outer lip edge and press into
track if caught on outer edge.
(B)
To insert your 4" ABS or PVC pipe:
Step 1 Cut pipe square.
Step 2 Chamfer end. Failure to do so can cut built-in ‘O’ rings off.
The ‘O’ rings in the Snap-in hub make the seal and are vital.
Step 3
USE ANY LIQUID SOAP and rub around the circumference of the
pipe approximately 102 mm (4") back from the chamfered end and
insert chamfered end of pipe into the Snap-in hub using sufficient
pressure to push pipe through the Snap-in hub. Extend pipe into
tank approximately 25 mm (1") beyond the inside edge of the snap-
in hub.
Caution:
DO NOT USE A TWISTING FORCE – rather, use a
sideways motion.
Step 4 Install non-corrosive clamp by placing the worm gear housing of
clamp in slot provided on the top of the Snap-in hub. Wrap strap
around inside the groove and tighten sufficiently.
Note: Snap-in hub is not mechanically sealed.
*Patent Applied For
Form No. 821711
Jackel. lnc./1982
Snap-in Hub
INSTALLATION INSTRUCTIONS
- 15 -
© Copyright 2019 Zoeller Co. All rights reserved.
®