7
© Copyright 2014 Zoeller Co. All rights reserved.
FLOAT SWITCH
CONTROL CHARGER
LOCKING PIN MUST BE
INSTALLED UNDER FLOAT
ROD IN THIS LOCATION.
UPPER RUBBER STOP NOT USED ON
FACTORY ASSEMBLED SYSTEMS.
R
R
GROUNDED POWER CORD
LCD
AC POWER
SCROLL
CHARGED
HIGH WATER
CHARGING
ALARM RESET
LOW BATTERY
ALARM OFF
ALARM
CONTACTS
GREEN LEAD
TO FLOAT SWITCH
NEGATIVE LEAD
POSITIVE LEAD
FIGURE 5
SK2503
FIGURE 6
SK2958
LCD DISPLAY AND KEYPAD FUNCTIONS
There are two buttons on the front of the charger:
• The scroll button is used to cycle through the information on the LCD screen.
• The alarm reset button:
° Can be pressed to clear alarm buzzer, light and/or display.
° Can be held for longer than 3 seconds to silence the buzzer for a 24-hour period.
The LCD screen will display information about the system by simply hitting the scroll button:
• The bottom line of the LCD will always display the battery voltage and current going to the battery, if charging.
• The alarm screen shows current alarms.
• The cycle counter screen shows how many times the DC float has been activated.
• The AC power loss counter screen shows how many times the AC power has been removed from the charger.
• Optional: a screen may also show the name and number of a service provider.
The 6 LED lights also display information about the charger at a glance:
• The red AC
power
light will be on if AC power is connected, and it will blink if AC power is not connected.
• The green
charged
light indicates a full battery, ready for operation.
• The yellow
charging
light indicates power going to the battery.
• The red
low battery
light blinks when the battery is below 10.8 volts and rapidly blinks when the battery is below 8.4 volts.
• The yellow
high water
light will blink when the float is activated, and becomes solid after 3 seconds.
NOTE: The pump should be running when the float is activated.
• The yellow
alarm off
light indicates the buzzer is currently silenced.
