background image

2

© 2020. All rights reserved.

Please read and understand this entire manual before attempting to assemble, operate, or install the 

product. 

•  NOTE

: Pumps with the “UL” Mark and pumps with the “US” mark are tested to UL Standard 

UL778. CSA certifi ed pumps are certifi ed to CSA Standard C22.2 No. 108. (CUS.)

•  ELECTRICAL SHOCK ALERT. 

To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor 

(GFCI). Make certain that the ground fault re cep ta cle is with in the reach of the pump’s pow er sup ply 

cord. DO NOT USE AN EX TEN SION CORD. 

•  ELECTRICAL SHOCK ALERT.

 

Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the 

Occupational Safety and Health Act (OSHA).

•  ELECTRICAL SHOCK ALERT.

 

Do not kink power cable, and never allow the cable to come in contact with oil, grease, hot surfaces, 

chemicals, or sharp objects. Replace damaged or worn wiring cord immediately.

•  ELECTRICAL SHOCK ALERT.

As a safe ty mea sure, each elec tri cal outlet should be checked for ground using an Under writ ers 

Labo ra tory List ed cir cuit an a lyz er, which will in di cate if the power, neu tral, and ground wires are 

cor rect ly con nected to your out let. If they are not, contact a li censed electrician.   

•  ELECTRICAL SHOCK ALERT.

These pumps are supplied with a 3-prong ground ed plug to help protect you against the pos si bil i ty of 

elec tri cal shock. DO NOT UN DER ANY CIR CUM STANC ES RE MOVE THE GROUND PIN.

•  ELECTRICAL SHOCK ALERT.

To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor 

(GFCI).

•  ELECTRICAL SHOCK ALERT.

Make sure the pump elec tri cal sup ply cir cuit is equipped with fuses or cir cuit break ers of prop er 

ca pac i ty.    A  sep a rate  branch  cir cuit  is  rec om mend ed,  sized  ac cord ing  the  Na tional  Elec tri cal  Code 

for the cur rent shown on the pump name plate.

•  CHEMICAL ALERT.

 

Prop65 Warning for California residents: WARNING: Cancer and Reproductive Harm - 

 www.P65Warnings.ca.gov

  

SAFETY INFORMATION

DANGER

•  ELECTRICAL SHOCK HAZARD.

Always disconnect power source before performing any work on or near the motor or its connected 

load.  If the power disconnect point is out-of-sight, lock it in the open position and tag it to prevent 

unexpected application of power.  Failure to do so could result in fatal electrical shock.

•  ELECTRICAL SHOCK HAZARD.

Do not handle the pump with wet hands or when standing in water as fatal electrical shock could 

occur.  Disconnect main power before handling unit for ANY REASON!

•  RISK OF ELECTRIC SHOCK. 

These pumps have not been investigated for use in swimming pool areas.

WARNING

2

© 2020. All rights reserved.

Please read and understand this entire manual before attempting to assemble, operate, or install the 

product. 

•  NOTE

: Pumps with the “UL” Mark and pumps with the “US” mark are tested to UL Standard 

UL778. CSA certifi ed pumps are certifi ed to CSA Standard C22.2 No. 108. (CUS.)

•  ELECTRICAL SHOCK ALERT. 

To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor 

(GFCI). Make certain that the ground fault re cep ta cle is with in the reach of the pump’s pow er sup ply 

cord. DO NOT USE AN EX TEN SION CORD. 

•  ELECTRICAL SHOCK ALERT.

 

Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the 

Occupational Safety and Health Act (OSHA).

•  ELECTRICAL SHOCK ALERT.

 

Do not kink power cable, and never allow the cable to come in contact with oil, grease, hot surfaces, 

chemicals, or sharp objects. Replace damaged or worn wiring cord immediately.

•  ELECTRICAL SHOCK ALERT.

As a safe ty mea sure, each elec tri cal outlet should be checked for ground using an Under writ ers 

Labo ra tory List ed cir cuit an a lyz er, which will in di cate if the power, neu tral, and ground wires are 

cor rect ly con nected to your out let. If they are not, contact a li censed electrician.   

•  ELECTRICAL SHOCK ALERT.

These pumps are supplied with a 3-prong ground ed plug to help protect you against the pos si bil i ty of 

elec tri cal shock. DO NOT UN DER ANY CIR CUM STANC ES RE MOVE THE GROUND PIN.

•  ELECTRICAL SHOCK ALERT.

To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor 

(GFCI).

•  ELECTRICAL SHOCK ALERT.

Make sure the pump elec tri cal sup ply cir cuit is equipped with fuses or cir cuit break ers of prop er 

ca pac i ty.    A  sep a rate  branch  cir cuit  is  rec om mend ed,  sized  ac cord ing  the  Na tional  Elec tri cal  Code 

for the cur rent shown on the pump name plate.

•  CHEMICAL ALERT.

 

Prop65 Warning for California residents: WARNING: Cancer and Reproductive Harm - 

 www.P65Warnings.ca.gov

  

SAFETY INFORMATION

DANGER

•  ELECTRICAL SHOCK HAZARD.

Always disconnect power source before performing any work on or near the motor or its connected 

load.  If the power disconnect point is out-of-sight, lock it in the open position and tag it to prevent 

unexpected application of power.  Failure to do so could result in fatal electrical shock.

•  ELECTRICAL SHOCK HAZARD.

Do not handle the pump with wet hands or when standing in water as fatal electrical shock could 

occur.  Disconnect main power before handling unit for ANY REASON!

•  RISK OF ELECTRIC SHOCK. 

These pumps have not been investigated for use in swimming pool areas.

WARNING

Summary of Contents for 1263-0001Q

















Reviews: