Zodiac Vortex OV 3400, Instructions For Installation And Use Manual

Page: 42 / 152

19
❺ Troubleshooti ng
• If a problem occurs, before you contact your retailer, please carry out these few simple checks
using the following tables.
• If the problem conti nues, contact your retailer.
• : Acti ons to be performed by a qualifi ed technician only.
5.1 I Appliance behaviour
Part of the pool is not correctly
cleaned
• Repeat the immersion steps (see § “3.3 Immersing the cleaner”), varying the
immersion locati on unti l you fi nd the right place in the pool.
The appliance does not stay fi rmly
on the pool bott om
• There is sti ll air in the appliance's casing. Repeat the immersion operati ons
(see § “3.3 Immersing the cleaner”).
• The fi lter is full or dirty: clean it.
• The fi lter is clogged: change it.
• The propeller is damaged, contact your retailer
The appliance does not or no
longer climbs the pool sides as it
originally did.
(Its electronic programme means
that the appliance does not
systemati cally climb the walls).
• The fi lter is full or dirty: clean it.
• The fi lter is clogged: change it.
• Even though the water seems clear, microscopic algae are present in your
pool. They are not visible to the naked eye, and they make the sides slippery
and prevent the appliance from climbing. Carry out shock chlorinati on and
slightly reduce the pH. Do not leave the appliance in the water during shock
treatment.
• The brushes are worn: check the wear indicators “4.3 I Replacing the
brushes”, then turn the brushes to check the rotati ons. Replace the brushes
where necessary.
• If the problem conti nues, contact your retailer.
The appliance does not move on
start-up.
• Check that the control box's power socket is receiving a power supply.
• Check that a cleaning cycle has been launched and that the lights are on.
• If the problem conti nues, contact your retailer.
The cable gets tangled • Do not unroll the enti re length of the cable into the pool.
• Place the required length of cable in the pool and spread the rest along the
side of the pool.
The cleaner's discharge nozzles or
bott om plug holes become blocked
• Stop the fi ltrati on pump and begin a new cleaning cycle.
• Place the control box in the centre of the pool's length, following the safety
conditi ons, see “3.4 I Electricity supply connecti ons”. If cleaning is not
opti mal, vary the locati on of the control box and the place at which the
cleaner enters the pool.
The cleaner climbs the walls slowly
and stops under the water line
The cleaner climbs the walls quickly
and goes past the water line,
aspirati ng air
• The cleaner may behave diff erently depending on the lining of the pool.
A parameter may require changing. To do this, contact your retailer .
The control box does not respond to
any butt on presses
• Unplug the power cord from the mains socket, wait 10 seconds and plug it
back in again.
The screen displays the message
when the remote control
mode is acti ve
• This means that the remote control batt eries are too low: change them.