2
1
Figure 1. Connect the Power Cord
To Disconnect:
•
Grip the power cord firmly on each side and
press two tabs to release (see Figure 2.)
Figure 2. Disconnect the Power Cord
1
2
2.4 Connecting to Power Source
WARNING
Failure to comply with the following warnings can
result in permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• Keep the control unit at least five 3.5 m from the
edge of the pool.
• The cleaner is to be installed in accordance with the
relevant requirements of South African wiring rules,
or in Australia within requirements of wiring rules AS/
NZS 3000. Also refer to the installation instructions
relating to the swimming pool equipment for which
the cleaner will be an integral part. The cleaner is
to be supplied through a Residual Current Device
(RCD) with a rated residual operating current of
30mA.
• Do not use an extension cord to connect the control
unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control unit is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control unit or leave exposed to inclement
weather.
To Connect:
•
Rotate the power cord so that TOP is shown on
the top side. Press the power cord firmly into
the control unit until you hear a "click" (see
Figure 1). The clicking indicates the power cord
is connected correctly creating a watertight seal.
Page
5
ENGLISH
Zodiac
®
FX20 FX30 FX35 Robotic Pool Cleaner
|
Owner's Manual
