Section 1.
Important Safety Instructions
Congratulations on purchasing the Zodiac Robotic Cleaner. Please read through the entire manual before installing
your new robotic pool cleaner. Your cleaner must be installed and operated as specified.
READ AND FOLLOW ALL INSTRUCTIONS
CAUTION
USE OF THE ZODIAC ROBOTIC CLEANER IN A VINYL LINER POOL
Certain vinyl liner patterns are particularly susceptible to rapid surface wear of pattern removal caused by objects coming into contact with
the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and automatic pool cleaners. Some vinyl liner
patterns can be seriously scratched or abraded simply by rubbing the surface with a pool brush. Ink from the pattern can also rub off during
the installation process or when it comes into contact with objects in the pool. Zodiac Pool Systems, Inc., is not responsible for, and the
Limited Warranty does not cover, pattern removal, abrasion or markings on vinyl liners.
SAVE THESE INSTRUCTIONS
WARNING
Failure to comply with the following warnings can result in permanent injury, electrocution or death.
PREVENT ELECTRICAL SHOCK
To reduce risk of electrical shock:
• The cleaner is to be installed in accordance with the relevant requirements of South African wiring rules, or in Australia within requirements of
wiring rules AS/NZS 3000. Also refer to the installation instructions relating to the swimming pool equipment for which the cleaner will be an
integral part. The cleaner is to be supplied through a Residual Current Device (RCD) with a rated residual operating current of 30mA.
• Do not enter pool while the robotic cleaner is in water.
• Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge trimmers and other equipment.
• To reduce the risk of electrical shock, do not use the robotic cleaner or control unit if the cord is worn or damaged. Immediately contact Zodiac
Customer Care Service for proper servicing and replacement of the damaged cord: Australia 1800 688 552, South Africa 0860 887 665.
• Double insulation—For continued protection against possible electric shock, use only identical replacement parts when servicing. Do not
attempt repair of the robotic cleaner, control unit, power cord, or floating cable.
• Use only the power supply provided with the product.
• NEVER OPEN CONTROL UNIT.
• DO NOT USE AN EXTENSION CORD TO CONNECT THE UNIT TO ELECTRIC SUPPLY; PROVIDE A PROPERLY LOCATED RCD
PROTECTED GFCI RECEPTACLE. THE CONTROL UNIT SHOULD BE PLACED NEAR THE RCD PROTECTED GFCI RECEPTACLE
BOX.
PREVENT CHILD INJURY AND DROWNING
• To reduce the risk of injury, do not permit children or persons with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge to operate this product.
• Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed as part of your pool’s operational system.
• Children should be supervised to ensure that they do not play with the appliance.
CAUTION
Failure to comply with the following warnings could cause damage to pool equipment or personal injury.
• The robotic cleaner must be installed and operated as specified.
• This product is intended for use with permanently-installed pools. Do not use with storable pools. A permanently-installed pool is constructed
in or on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable
of being readily disassembled for storage and reassembled to its original integrity.
• Clean the filter canister after each use.
• Do not use the product in your pool if the water temperature is above 35˚ C (95˚ F) or below 13˚ C (55˚ F).
Page
3
ENGLISH
Zodiac
®
FX20 FX30 FX35 Robotic Pool Cleaner
|
Owner's Manual
