![background image](http://html.mh-extra.com/html/zodiac/sweepy-m3/sweepy-m3_user-manual_936500004.webp)
How to install your Sweepy M3
™
?
1. Unpacking
• The following items should be in the packaging :
- your Sweepy M3
™
robot
- its carrying trolley including the control box
• Make sure your appliance has not been damaged in transit (impact, broken parts etc.). If you notice
the slightest fault, however minor, do not hesitate to contact your retailer before using your
Sweepy M3
™
.
• Assembling the carrying trolley
Before removing the appliance from the box :
- Loosen the round black knobs on the transport trolley as far as they will go (they should pull out by
approximately 1 cm) ;
- Fold out the carrying trolley (Fig. 1) ;
- Retighten the black knobs on the trolley (Fig. 2) ;
Take the robot out of the box, then the trolley ;
- Put the hooks used to rewind and store the cable towards the rear (Fig. 3).
2. Electrical Connection
For your own safety and to ensure that your Sweepy M3
™
functions properly, proceed as follows:
• Put the control box at least 3.5 metres away from the edge of the pool avoiding direct exposure to
the sun.
• Fix to the ground using the fixing dowels supplied, and lock the trolley foot into them to immobilise
the trolley (Fig. 4).
• Connect the robot cable to the control box and screw the connector tight.
• Lift the lid of the control box (Fig. 5).
• Make absolutely sure that the «I/O» [On/Off] switch is set to «O» (Fig. 6) ; the robot may be
seriously damaged if it is switched on whilst it is out of the water.
• Only connect the control box to an earthed electrical socket fitted with a maximum 30 mA residual
current protection device (if you are not sure, contact your installer’s electrician ).
16
1
Summary of Contents for Sweepy M3
Page 1: ...ENGLISH 13 ...