FRAME INSTALLATION
14
STEP 8. ASSEMBLY
Identify the P. posts, joiner channels (female E), joiner channels (male D) and joiner hardware (nuts,bolts & washers) required
for your size of pool.
Lay these components out on the ground in their correct order and assemble them as per the instructions in step 9. below
NOTE:
Refer to page 17 for the layout of the size of the pool you have purchased.
NOTE:
1. Diagram shows assembly for a 3706mm
wide section.
2. 4616 wide pools have 5 joiners in each
section (2 x E joiners , 2 x D joiners and
1 x C joiner
STEP 9. FRAME ASSEMBLY
Once the joiner channels have been assembled and bolted together the channel assembly is to be attached to the P.Posts.The same
components are used for both 3.6m wide pools and 4.5m wide pools, except a C Female joiner is added to the 4.5m pools.The
joining configurations are shown below.
4.5m wide
3.8m wide
Bolt
N
u
t
Washer
Joi
n
er cha
nn
el
m
ale
Joi
n
er cha
nn
el
f
e
m
ale
D Male
D Male
E Female
Exploded view
E Female
D Male
D Male
E Female
E Female
D Male
D Male
C Female
E Female
E Female
Summary of Contents for NOOSA REEF
