9
❸ Use
3.1 I Operating principle
The hydraulic cleaners connect to the filtration system (either to a suction line or a skimmer); they use the filtration
pump’s energy to move around the pool. The wall climbing capacity varies according to the shape of the pool and the
available water flow.
The debris is sucked in by the cleaner and captured in the filtration pump's filter basket
or in the
Cyclonic
TM
Leaf Catcher
(accessory included or available as an option depending on the model).
3.2 I Pool preparation
•
This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
•
The device must operate in pool water with the following quality:
Water temperature
Between 15°C and 35°C
pH
Between 6.8 and 7.6
Chlorine
< 3 mg/ l
•
When the pool is dirty, especially when first installing your cleaner, remove the largest debris using a telescopic pole
and net prior to installing the cleaner.
•
Remove any thermometers, toys and other objects that might damage the device.
•
After adding chemical products to the water, wait at least 4 hours before putting the cleaner into the water.
•
Make sure that the filtration and the skimmer baskets are clean.
•
Aim the pool return lines downward if adjustable.
•
Close the pool’s main drain line.
•
Turn off the filtration pump off.
3.3 I Operating
•
To avoid serious injury, make sure the filtration pump is turned off.
•
Do not expose your hair, loose clothing, jewellery, etc. to the open end of the hose.
3.3.1 Connecting the flow regulator valve and immersing the cleaner
•
Connect the flow regulator valve to the hose (see image )
.
•
Immerse the cleaner so that it fills up with water.
•
When there are no more air bubbles escaping from the cleaner, connect the hose by inserting the flow regulator valve
onto the cleaner (see image )
.
•
Let the cleaner descends to the bottom of the pool.
3.3.2 Filling the hose assembly
•
Disconnect the hose assembly from the suction line or skimmer temporarily.
•
Turn on the filtration pump.
•
Fill the Hose assembly with water by placing the open end in front of a pool return line until it is filled.
•
Turn off the filtration pump and connect the Hose assembly to the dedicated suction line or skimmer.
•
Turn on the filtration pump on to activate the pool cleaner.
EN
