10
Position "Waste"
This is carried out to drain the pool or lower the water level. The water
is sent directly to the evacuation without going through the filter.
•
In this case, and if the pool has a bottom plug hole,
aspirate the water through the bottom plug hole only to
prevent air from getting into the pipes.
: Pool suction = open
: Pool discharge = closed
: Filter inlet or outlet = closed
: Discharge to the drainage system = open
Position "Recirculate"
Water is circulated without going through the filter and sent directly
to the pool.
: Pool suction = open
: Pool discharge = open
: Filter inlet or outlet = closed
: Discharge to the drainage system = closed
Position "Closed"
Water no longer circulates in the multiway valve or the filter.
•
Do not run the filtration pump when the valve is in this
position!
: Pool suction = closed
: Pool discharge = closed
: Filter inlet or outlet = closed
: Discharge to the drainage system = closed
Tip : winterizing the filter
•
When the pool is winterised (reduced water level and pipes drained), set the valve to the intermediate
position (between any 2 settings). This position sets the internal gaskets of the multiway valve to standby
to protect them and keep them in good condition.
EN
Summary of Contents for MS FILTER D470
Page 15: ......
