LED Lights
The Sensor Nav System
™
LED is located on the
front of the cleaner. This light indicates status,
either:
Blinking Blue - Sensing, Scanning and Cleaning
Solid Blue - Cleaning
Blinking Green - Lift System or Spot Cleaning
Solid Green - Remote Control
On some models, an LED light illuminates the
interior area of the body and canister.
NOTE: LED lights may be difficult to see in sunlight.
In-App Error Messages and
Troubleshooting
If an error occurs, the status bar will show a
warning symbol and: "Cleaning Interrupted".
1. Click on the warning symbol to view
troubleshooting advice
on how to fix the issue.
2. Choose
Clear Error
if you believe you have
fixed the problem and want to re-try. Choose
OK
if you want to suspend the cleaner in error
mode and work on the troubleshooting fix at a
later time.
System Settings
Access System Settings by pressing the gear icon
in the upper right hand corner of the app screen.
7
Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.
Cord Tangling
Tangling can occur more frequently when the
cleaner is not attended to after each cleaning
cycle. The tangle-reducing swivel, in addition to
proper installation, general maintenance and the
following troubleshooting steps can help to avoid
cable challenges.
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
NOTE:
For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length. Only place enough cable in the
water to reach the farthest point in the pool.
Max
Floating Cable
Length
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
WARNING:
Do not use
an extension cord
Figure 14. Optimal Entry Point in Pool
Page
16
Zodiac
®
EvoluX
™
iQ Robotic Pool Cleaner
|
Owner's Manual
