23
22
3. Electrical connection
- Connect the robot cable to the control box and screw
the connector tight (diagram 4).
- Lift the lid of the control box (diagram 5).
- Make absolutely sure that the "On(I)/Off(O)" switch is set to Off(O);
the robot may be seriously damaged if it is switched on whilst it is
out of the water.
- Only connect the control box to an earthed electrical socket fitted
with a maximum 30 mA residual current protection device
(if you are not sure, contact your installer's electrician).
Diagram 6
Diagram 7
Diagram 8
1. Immersing the robot
IMPORTANT: Do not allow any bathing while your CYBERNAUT ™ is in the pool.
..
Preferably work from one corner of the shallow end of your pool while
carrying out the following steps.
S T E P 1
Push the robot down into the
water and evacuate the air it
contains by turning it over
(diagram 6).
S T E P 2
Use your hands to press on the
foam brushes to push out the air
and take in water (diagram 7).
This procedure is not required
with rubber brushes.
S T E P 3
It is essential that the appliance goes down by itself and rests on the bottom of the pool.
We advise you to place the robot in a corner at the shallow end and position it so that it
will start moving across the width of the pool. The cable should be positioned towards the
middle of the pool (diagram 8).
How to use
2.
your CYBERNAUT
™
AUTO
AUTO
M
Diagram 5
Diagram 4
